Difference between revisions of "ESWIN EMU32VL170 TEST BRD"
(→Preparing for J-Link) |
|||
| Line 5: | Line 5: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
| − | *Connect the J-Link to |
+ | *Connect the J-Link to J88. |
| − | *Power the board via |
+ | *Power the board via J91. |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
| − | '''[PICTURE OF CONNECT]''' |
||
[[File:ESWIN_EMU32VL170_TEST_BRD_EMU32VL170_connect.png|400px]] |
[[File:ESWIN_EMU32VL170_TEST_BRD_EMU32VL170_connect.png|400px]] |
||
Revision as of 08:51, 28 September 2023
This article describes specifics for the ESWIN EMU32VL170 TEST BRD evaluation board.
Preparing for J-Link
- Connect the J-Link to J88.
- Power the board via J91.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ESWIN EMU32VL170 TEST BRD.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.xx
- Embedded Studio: V7.20
- Hardware: [SiliconVendor] [EvalBoardName]
- Link: File:VENDOR DEVICENAME TestProject ES V452b.zip
