Difference between revisions of "ESWIN ECR2560 FULLMASK 40PIN EVK"
| Line 8: | Line 8: | ||
*Power the board via 13. |
*Power the board via 13. |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
| − | [[File:ESWIN_ECR2560_FULLMASK_40PIN_EVK_ECR2560_connect|400px]] |
+ | [[File:ESWIN_ECR2560_FULLMASK_40PIN_EVK_ECR2560_connect.png|400px]] |
== Example Project== |
== Example Project== |
||
Revision as of 10:17, 28 September 2023
This article describes specifics for the ECR2560 FULLMASK 40PIN EVK evaluation board.
Preparing for J-Link
- Connect the J-Link to J18.
- Power the board via 13.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ESWIN ECR2560 FULLMASK 40PIN EVK.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.67c
- Embedded Studio: V7.20
- Hardware: ESWIN ECR2560 FULLMASK 40PIN EVK
- Link: File:ESWIN ECR2560 FULLMASK 40PIN EVK ECR2560 TestProject ES 7V20.zip
