Difference between revisions of "Infineon REF WLC TX15W C1"

From SEGGER Wiki
Jump to: navigation, search
(Created page with "Category:Evalboards __TOC__ This article describes specifics for the Infineon REF_WLC_TX15W_C1 evaluation board.<br> File:Infineon_REF_WLC_TX15W_C1_WLC1115-68QLXQ_board...")
 
(→‎Preparing for J-Link)
Line 23: Line 23:
 
| 5V-SUPPLY || J2 || 5 || VTARG
  
| 5V-SUPPLY || J2 || 5 || VTARG
 
|}
  
|}
−
* Supply the board using the J-Link 5V-SUPPLY Output[[J-Link_Commander#Power| J-Link 5V-SUPPLY]].
 +
* Supply the board using the [J-Link_Commander#Power| J-Link 5V-SUPPLY].
 
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
  
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
 
[[File:Infineon_REF_WLC_TX15W_C1_WLC1115-68QLXQ_connect|400px]]
  
[[File:Infineon_REF_WLC_TX15W_C1_WLC1115-68QLXQ_connect|400px]]

Revision as of 10:57, 30 May 2024

This article describes specifics for the Infineon REF_WLC_TX15W_C1 evaluation board.
450px

Preparing for J-Link

  • Connect the J-Link to this pins:
J-Link Pin Connector Pin Name
VTref J2 5 VTARG
GND J2 4 GND
TMS/SWDIO J2 1 HPI_I2C_SDA
TCK/SWCLK J2 2 HPI_I2C_SCL
RESET J2 3 RESET
5V-SUPPLY J2 5 VTARG
  • Supply the board using the [J-Link_Commander#Power| J-Link 5V-SUPPLY].
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

400px

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=Infineon_REF_WLC_TX15W_C1&oldid=20053"