Difference between revisions of "GigaDevice GD32E235C-EVAL"
| Line 30: | Line 30: | ||
*Embedded Studio: V7.20 |
*Embedded Studio: V7.20 |
||
*Hardware: GigaDevice GD32E235C-EVAL |
*Hardware: GigaDevice GD32E235C-EVAL |
||
| − | *Link: [[File: |
+ | *Link: [[File:GigaDevice_GD32E235CBT6._TestProject_ES_7V20.zip]] |
Revision as of 14:02, 13 June 2024
This article describes specifics for the GigaDevice GD32E235C-EVAL evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
| J-Link Pin | Connector | Pin | Name |
|---|---|---|---|
| VTref | JP1 | 1 | +3V3 |
| GND | JP1 | 4 | GND |
| TMS/SWDIO | JP1 | 2 | IO |
| TCK/SWCLK | JP1 | 3 | CLK |
- Power the board via CN100.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32E235C-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V7.20
- Hardware: GigaDevice GD32E235C-EVAL
- Link: File:GigaDevice GD32E235CBT6. TestProject ES 7V20.zip
