Difference between revisions of "WSL"
Line 4: | Line 4: | ||
As of now WSL does not fully support USB devices. |
As of now WSL does not fully support USB devices. |
||
− | In order to connect to a J-Link from WSL you either have to use the ethernet / WiFi interface (if present |
+ | In order to connect to a J-Link from WSL you either have to use the ethernet / WiFi interface (if present, see [https://www.segger.com/products/debug-probes/j-link/models/model-overview/ Model overview]) |
or make use of the [[J-Link_Remote_Server | J-Link Remote Server ]] that runs on an another machine, capable of USB. |
or make use of the [[J-Link_Remote_Server | J-Link Remote Server ]] that runs on an another machine, capable of USB. |
||
Revision as of 14:39, 27 April 2020
Windows subsystem for Linux (WSL) is a part of Windows 10, that allows the user to run Linux applications on Windows.
J-Link specifics
As of now WSL does not fully support USB devices.
In order to connect to a J-Link from WSL you either have to use the ethernet / WiFi interface (if present, see Model overview) or make use of the J-Link Remote Server that runs on an another machine, capable of USB.
Example setup with USB
In this example we will connect to our J-Link (connected via USB) from WSL using the J-Link Remote Server on the host side and the J-Link Commander on the WSL side.
Requirements
- J-Link connected via USB to the host Windows 10 system
- WSL system that has the J-Link Software and Documentation Pack installed
Steps
- Start the J-Link Remote Server in LAN mode on the Windows 10 host system.
- Switch to the command-line prompt of your WSL Linux system
- Insert your target device into the following command and execute it:
JLinkExe -device <insert-your-device> -ip localhost -if SWD -speed 4000 -autoconnect 1