NXP RD-RW616-BGA IPA-2A/1A

From SEGGER Wiki
Revision as of 15:40, 24 August 2023 by Torben.scharping (talk | contribs)
Jump to navigation Jump to search
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.

This article describes specifics for the NXP RD-RW616-BGA_IPA-2A/1A evaluation board.
NXP RD-RW612-BGA RW612EV board.jpg

Preparing for J-Link

  • Connect the J-Link to P2
  • Power the board via J1
  • Jumper JP1 must be set in order to use J-Link
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

[PICTURE OF CONNECT] VENDOR DEVICE CONNECT.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP RD-RW616-BGA_IPA-2A/1A.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=NXP_RD-RW616-BGA_IPA-2A/1A&oldid=16149"