NXP RD-RW616-BGA IPA-2A/1A
Revision as of 15:40, 24 August 2023 by Torben.scharping (talk | contribs)
This article describes specifics for the NXP RD-RW616-BGA_IPA-2A/1A evaluation board.
Preparing for J-Link
- Connect the J-Link to P2
- Power the board via J1
- Jumper JP1 must be set in order to use J-Link
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP RD-RW616-BGA_IPA-2A/1A.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: NXP RD-RW616-BGA_IPA-2A/1A
- Link: File:VENDOR DEVICENAME TestProject ES V452b.zip