Mindmotion Mini-F5233-MM32F5233D7P
Revision as of 08:33, 7 September 2023 by Torben.scharping (talk | contribs)
This article describes specifics for the Mindmotion Mini-F5233 MM32F5233D7P evaluation board.
Minimum requirements
- J-Link software V7.92d or later
Preparing for J-Link
- Connect the J-Link to the SWD header (P15)
- Power the board via external power supply / power jack (J4)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion PLUS5270 MM32F5270.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82b
- Embedded Studio: V6.34
- Hardware: Mindmotion PLUS5270 MM32F5270
- Link: File:MM Mini-F5233 MM32F5233D7P TestProject ES 7V20.zip