Flasher/Differences between Flasher ATE, Flasher Hub and Flasher Hub-12
Direct Comparison
Flasher ATE | Flasher Hub | Flasher Hub-12 | ||
---|---|---|---|---|
Host Interfaces | Ethernet (10/100MBit) USB2.0 (High-Speed), USB Type B RS232 9-pin |
Ethernet (10/100/1000MBit) |
Ethernet (10/100/1000MBit) USB2.0 (High-Speed), USB Type B RS232 9-pin | |
Maximal direct parallel programming channels (with chaining) | 10 (n/a) | 24 (n/a) | 12 (48) | |
Internal system connection | Internal proprietary bus, daisy chained | USB Type A to USB-micro, USB 2.0 | USB Type C to USB-micro, USB 2.0 | |
System power supply | Connection terminals/USB-B 5V/3A max. |
USB-C 5V/1.5A min. |
Connection terminals 12..30V/60W | |
Target power supply (selectable) | none 5V/100mA (internal system power) 1.5…15V/400 mA (externally supplied power) |
none 5V/400mA max. (USB power) |
none 5V/400mA max. (USB power) | |
Form factor |
|
|
| |
Components needed for | minimal setup 1 channel |
1x Main Module 1x Programming Module |
1x Flasher Hub 1x Flasher Compact 1x USB-A to USB-micro cable |
1x Flasher Hub-12 1x Flasher Compact 1x USB-C to USB-micro cable |
4 channels | 1x Main Module 4x Programming Module |
1x Flasher Hub[2] 4x Flasher Compact 4x USB-A to USB-micro cable 1x 7-port USB-2.0-Hubs[2] |
1x Flasher Hub-12 4x Flasher Compact 4x USB-C to USB-micro cable | |
full setup | 1x Main Module 10x Programming Module |
1x Flasher Hub 24x Flasher Compact 24x USB-A to USB-micro cable 4x 7-port USB-2.0-Hubs[3] |
4x Flasher Hub-12 48x Flasher Compact 48x USB-C to USB-micro cable | |
Use cases |
|
|
|
- ↑ 1.0 1.1 If space is limited, it is possible to remove the Flasher Compact without the housing. The bare PCB provides mounting holes.
- ↑ 2.0 2.1 It is not recommended to directly connect Flasher to Hub, please always use a powered USB-Hub.
- ↑ Due to a hardware limitation of the USB host controller IC, the number of enumerable device endpoints is limited to 31. Some USB hubs (especially USB-3) occupy up to 3 device endpoints. Therefore, it may be a challenge to connect all 24 flashers and the fail-save USB drive. If you have such problems, please contact SEGGER. We also offer USB hubs that avoid these problems: Segger USB Hub