Renesas EK-RA2A2
Revision as of 17:22, 15 March 2024 by Joshua.Kozian (talk | contribs)
This article describes specifics for the Renesas EK-RA2A2 evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | J2 | 1 | VCC |
GND | J2 | 20 | VSS |
TMS/SWDIO | J2 | 18 | P108/SWDIO |
TCK/SWCLK | J2 | 17 | P300/SWCLK |
- Power the board via J10.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA2A2.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V7.12a
- Hardware: Renesas EK-RA2A2
- Link: File:TODO.zip