GigaDevice GD32350R-EVAL
Revision as of 14:26, 3 April 2024 by Joshua.Kozian (talk | contribs)
This article describes specifics for the GigaDevice GD32350R-EVAL evaluation board.
Preparing for J-Link
- Connect the J-Link to the JTAG header (JP3)
- Power the board via CN1.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32350R-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V8.10a
- Hardware: GigaDevice GD32350R-EVAL
- Link: File:GigaDevice GD32F350RB TestProject ES V810a.zip