ST NUCLEO-WBA52CG
Revision as of 17:30, 2 April 2024 by Torben.scharping (talk | contribs)
This article describes specifics for the ST NUCLEO-WBA52CG evaluation board.
Preparing for J-Link
- Connect the J-Link to CN3-8(GND) CN3-9(SWDIO) CN3-11(SWDCLK) CN3-12(VTref) CN3-14(Reset).
- Set Jumper JP1 to 5-6 (5VINT)
- Power the board via CN3-22(GND) CN3-24(5V).
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-WBA52CG.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.88k
- Embedded Studio: V6.52b
- Hardware: ST NUCLEO-WBA52CG
- Link: File:ST NUCLEO-WBA52CG STM32WBA52CG TestProject ES V634.zip