J-Link OB SAM3U NordicSemi
Contents
VCOM functionality
This J-Link model supports VCOM.
Pin driving policy
The following pins are available on this OB:
- OB_Tx (driven by J-Link OB)
- OB_Rx (driven by target)
- CTS (driven by target. LOW == Target ready to receive data)
- RTS (driven by J-Link OB. LOW == J-Link OB ready to receive data)
J-Link OB starts driving its VCOM output pins as soon as it receives a "set baudrate" command. This command is send by the PC as soon as a COM port is opened. Unfortunately, there is no specific command / packet etc. send by the PC in case a COM port is opened. Therefore the "set baudrate" approach is the only one to detect COM port activity.
J-Link OB stops driving the RTS pin if J-Link OB detects that hardware flow control is not used on the target side.
Hardware flow control support
Hardware flow control is supported by this J-Link OB. By default, J-Link detects at runtime if the target uses flow control or not. This is done as follows:
- If CTS is detected as HIGH (Target not ready) before the first character is sent by J-Link OB, the pin is assumed to be not used by the target and flow control on the J-Link side gets disabled (CTS is ignored from now on, J-Link stops driving RTS)
Force or disable hardware flow control
It is possible to configure J-Link OB to bypass the hardware flow control auto-detection in the firmware and assume that hardware flow control is always or never used. This can be done via J-Link Commander and the following command:
<!-- This entry will overwrite the existing device entry in the J-Link software, so that a custom flash algorithm is used for the internal flash --> <ChipInfo Vendor="ST" Name="STM32F767ZI" Core="JLINK_CORE_CORTEX_M7" /> <FlashBankInfo Name="Internes Flash" BaseAddr="0x08000000" MaxSize="0x00200000 " Loader="ST_STM32F7xxxx_2MB_DualBank.elf" LoaderType="FLASH_ALGO_TYPE_OPEN" /> </Device>