CMSemicon BAT32G133-EVB
Revision as of 15:55, 11 November 2022 by Thomas.haase (talk | contribs) (Created page with "__TOC__ This article describes specifics for the CMSemicon BAT32G1xxGx evaluation boards. ==BAT32G133-EVB== '''PICTURE will follow''' ==BAT32G157-EVB== '''PICTURE will fo...")
Contents
This article describes specifics for the CMSemicon BAT32G1xxGx evaluation boards.
BAT32G133-EVB
PICTURE will follow
BAT32G157-EVB
PICTURE will follow
Minimum requirements
- J-Link software V7.__b or later
Preparing for J-Link
- Solder Header to the board (row on the side of the Chip)
Device Side | J-Link Signal | Pin |
---|---|---|
CLK | SWCLK | 9 |
DAT | SWDIO | 7 |
RST | RESET | 15 |
GND | GND | 4 |
VDD | VTRef | 1 |
- Power the board via USB
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the .
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82b
- Embedded Studio: V6.34
- Hardware:
- Link: