e-peas EDMS105N EVK
This article describes specifics for the e-peas EDMS105N_EVK evaluation board.
[PICTURE OF BOARD]
450px
Preparing for J-Link
- Connect the J-Link to ......
- Power the board via........
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the e-peas EDMS105N_EVK.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.88k
- Embedded Studio: V6.34
- Hardware: e-peas EDMS105N_EVK
- Link: File:Epeas EDMS105N TestProject ES V634.zip