ESWIN EMU32VL170 TEST BRD
Revision as of 08:51, 28 September 2023 by Torben.scharping (talk | contribs) (→Preparing for J-Link)
This article describes specifics for the ESWIN EMU32VL170 TEST BRD evaluation board.
Preparing for J-Link
- Connect the J-Link to J88.
- Power the board via J91.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ESWIN EMU32VL170 TEST BRD.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.xx
- Embedded Studio: V7.20
- Hardware: [SiliconVendor] [EvalBoardName]
- Link: File:VENDOR DEVICENAME TestProject ES V452b.zip