GigaDevice GD32350C-START
Revision as of 17:54, 27 February 2024 by Joshua.Kozian (talk | contribs) (Created page with "__TOC__ This article describes specifics for the GigaDevice GD32350C-START evaluation board.<br> 450px == Preparing fo...")
This article describes specifics for the GigaDevice GD32350C-START evaluation board.
450px
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | JP100 | 1 | +3V3 |
GND | JP100 | 4 | GND |
TMS/SWDIO | JP100 | 2 | L SWDIO |
TCK/SWCLK | JP100 | 3 | L SWDCK |
- Power the board via CN100.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32350C-START.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V7.12a
- Hardware: GigaDevice GD32350C-START
- Link: File:GigaDevice GD32330CB TestProject ES V712a.zip