NXP MCX-N9XX-EVK
Revision as of 10:53, 22 May 2023 by Torben.scharping (talk | contribs)
This article describes specifics for the NXP X-MCX-N9XX-EVK evaluation board.
Preparing for J-Link
- Connect the J-Link to J11, J6 hast to set in order to disable MCU-Link on the PCB and work with J-Link.
- Power the board via J5,J27,J28 (depending on setting of J26)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP X-MCX-N9XX-EVK.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: NXP X-MCX-N9XX-EVK
- Link: File:NXP MCXN947 TestProject ES V634.zip