GigaDevice GD32L235R-EVAL
Revision as of 13:48, 13 June 2024 by Torben.scharping (talk | contribs)
This article describes specifics for the GigaDevice GD32L235R-EVAL evaluation board.
Preparing for J-Link
- Connect the J-Link to ......
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | |||
GND | |||
nTRST | |||
TDI | |||
TMS/SWDIO | |||
TCK/SWCLK | |||
RTCK | |||
TDO/SWO | |||
RESET | |||
DBGRQ | |||
5V-Supply |
- Power the board via........
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32L235R-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V7.20
- Hardware: GigaDevice GD32L235R-EVAL
- Link: File:GigaDevice GD32L235R. TestProject ES 7V20.zip