GigaDevice GD32E235C-EVAL
Revision as of 14:02, 13 June 2024 by Torben.scharping (talk | contribs)
This article describes specifics for the GigaDevice GD32E235C-EVAL evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | JP1 | 1 | +3V3 |
GND | JP1 | 4 | GND |
TMS/SWDIO | JP1 | 2 | IO |
TCK/SWCLK | JP1 | 3 | CLK |
- Power the board via CN100.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32E235C-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V7.20
- Hardware: GigaDevice GD32E235C-EVAL
- Link: File:GigaDevice GD32E235CBT6. TestProject ES 7V20.zip