Nuvoton-NuMaker-M071MD
Revision as of 19:47, 16 January 2023 by Torben.scharping (talk | contribs)
This article describes specifics for the Nuvoton NuMaker-M071MD evaluation board.
Preparing for J-Link
- Connect the J-Link to ......
- Power the board via J3 or ICE J3
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton NuMaker-M071MD.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: Nuvoton NuMaker-M071MD
- Link: File:Nuvoton NuMaker-M071MD M071MD2AE TestProject ES V634.zip