Nuvoton-NuMaker-M071R1E

This article describes specifics for the Nuvoton NuMaker-M071R1E evaluation board.

Preparing for J-Link

• Connect the J-Link : VTref=J1-2 / SWDIO=J1-4 / SWCLK=J1-6 / GND=J1-10
• Power the board via J3 or ICE J3
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton NuMaker-M071MD.
It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V6.74
• Embedded Studio: V4.52b
• Hardware: Nuvoton NuMaker-M071MD
• Link: File:Nuvoton_NuMaker-M071MD_M071MD2AE_TestProject_ES_V634.zip