MindMotion Mini-A0144

From SEGGER Wiki
Jump to: navigation, search

This article describes specifics for the MindMotion Mini-A0144 evaluation board.
[PICTURE OF BOARD] 450px

Preparing for J-Link

  • Connect the J-Link to CN7.
  • Power the board via CN1.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

MindMotion Mini-A0144 MM32A0144C6PM connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the MindMotion Mini-A0144 .
It is a simple Hello World sample linked into the internal flash.

SETUP