e-peas EDMS105N EVK

From SEGGER Wiki
Revision as of 15:59, 29 June 2023 by Torben.scharping (talk | contribs) (→‎SETUP)
Jump to: navigation, search

This article describes specifics for the e-peas EDMS105N_EVK evaluation board.
[PICTURE OF BOARD] 450px

Preparing for J-Link

  • Connect the J-Link to ......
  • Power the board via........
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

[PICTURE OF CONNECT] VENDOR DEVICE CONNECT.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the e-peas EDMS105N_EVK.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=e-peas_EDMS105N_EVK&oldid=15381"