MindMotion FTHR-G0001
Revision as of 14:01, 8 September 2023 by Torben.scharping (talk | contribs) (Created page with "__TOC__ This article describes specifics for the MindMotion FTHR-G0001 evaluation board.<br> 450px == Preparing for J-L...")
This article describes specifics for the MindMotion FTHR-G0001 evaluation board.
450px
Preparing for J-Link
- Connect the J-Link to CN2.
- Power the board via USB-C.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the MindMotion FTHR-G0001 .
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.92e
- Embedded Studio: V7.20
- Hardware: MindMotion FTHR-G0001
- Link: File:MindMotion FTHR-G0001 MM32G0001A1T TestProject ES 7V20.zip