NXP MCX-N9XX-BRK
Revision as of 16:11, 15 December 2023 by Torben.scharping (talk | contribs) (Created page with "__TOC__ This article describes specifics for the NXP MCX-N9XX-BRK7 evaluation board.<br> 450px == Preparing for J-Link == *Connect the J-...")
This article describes specifics for the NXP MCX-N9XX-BRK7 evaluation board.
Preparing for J-Link
- Connect the J-Link to J11, J6 hast to set in order to disable MCU-Link on the PCB and work with J-Link.
- Power the board via J5,J27,J28 (depending on setting of J26)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP MCX-N9XX-BRK.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V9.74
- Embedded Studio: V6.34
- Hardware: NXP MCX-N9XX-BRK
- Link: File:NXP MCXN947 TestProject ES V634.zip
