GigaDevice GD32407H-START
Revision as of 16:47, 31 May 2024 by Joshua.Kozian (talk | contribs) (Created page with "Category:Evalboards __TOC__ This article describes specifics for the GigaDevice GD32407H-START evaluation board.<br> File:GigaDevice_GD32407H-START_GD32F407VK_picture.j...")
This article describes specifics for the GigaDevice GD32407H-START evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | JP6 | 2 | +3V3 |
GND | JP6 | 1 | GND |
TMS/SWDIO | JP6 | 33 | PA13 |
TCK/SWCLK | JP5 | 32 | PA14 |
- Power the board via CN3.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32407H-START.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V8.10b
- Hardware: GigaDevice GD32407H-START
- Link: File:GigaDevice GD32F407VK TestProject ES V810b.zip