GigaDevice GD32L233C-STARTR
Revision as of 15:46, 7 June 2024 by Joshua.Kozian (talk | contribs) (Created page with "Category:Evalboards __TOC__ This article describes specifics for the GigaDevice GD32L233C-STARTR evaluation board.<br> File:GigaDevice_GD32L233C-STARTR_GD32F103VC_pictu...")
This article describes specifics for the GigaDevice GD32L233C-STARTR evaluation board.
450px
Preparing for J-Link
- Connect the J-Link to this pins:
| J-Link Pin | Connector | Pin | Name |
|---|---|---|---|
| VTref | JP5 | 19 | +3V3 |
| GND | JP6 | 1 | GND |
| TMS/SWDIO | JP6 | 40 | PA13 |
| TCK/SWCLK | JP5 | 37 | PA14 |
- Power the board via CN1.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32L233C-STARTR.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V8.10b
- Hardware: GigaDevice GD32L233C-STARTR
- Link: File:GigaDevice GD32F103VC TestProject ES V810b.zip
