Microchip WBZ450 Curiosity
Revision as of 15:51, 19 June 2024 by Artjom.Kister (talk | contribs) (Created page with "800px|thumb|right|Microchip WBZ450 Curiosity evaluation board This article describes specifics for the Microchip WBZ450 Curiosity...")
This article describes specifics for the Microchip WBZ450 Curiosity evaluation board. It can be used to test & verify Microchip PIC32CX-BZ2 device support.
Minimum requirements
- J-Link software V7.96m or later
Preparing for J-Link
- Connect the J-Link to the SWD header (J10).
- Power the board via the USB jack of the break out board (J7).
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Microchip WBZ450 Curiosity. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.96m
- Embedded Studio: V8.12a
- Hardware: Microchip WBZ450 Curiosity
- Link: File:Microchip WBZ450 Curiosity TestProject ES 8V12a.zip