CVA BlueWhale CVM0128-EVB
Revision as of 09:27, 26 June 2024 by Erik (talk | contribs) (Created page with "Category:Evalboards __TOC__ This article describes specifics for the CVA BlueWhale CVM0128-EVB evaluation board. It can be used to test & verify CVM012x device support....")
This article describes specifics for the CVA BlueWhale CVM0128-EVB evaluation board. It can be used to test & verify CVM012x device support.
Minimum requirements
- J-Link software V7.98 or later
Preparing for J-Link
- Select MCU to be powered (short JP8)
- Select MCU operating voltage 5V (short JP1 2&3)
- Select USB as power supply (short JP2 2&3)
- Connect the J-Link to the JTAG connector (J8)
- Power the board via external power supply USB (J11)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows: