ST STM32MP1
Overview
The STM32MP15x is a heterogeneous dual-core MCU with a Cortex-M4 and one or two Cortex-A7 cores.
Supported QSPI modes
Currently, J-Link supports Dual QSPI Flash-Mode and Single QSPI Flashbank(Bank 1 or Bank2) programming.
Default QSPI Pin mapping
Port | Pin | Pin Function | Alt Func |
GPIO_B | 6 | QSPI_BK1_NCS | AF_10 |
GPIO_F | 6 | QSPI_BK1_IO3 | AF_9 |
GPIO_F | 7 | QSPI_BK1_IO2 | AF_9 |
GPIO_F | 9 | QSPI_BK1_IO1 | AF_10 |
GPIO_F | 8 | QSPI_BK1_IO0 | AF_10 |
GPIO_F | 10 | QSPI_CLK | AF_9 |
GPIO_C | 0 | QSPI_BK2_NCS | AF_10 |
GPIO_G | 7 | QSPI_BK2_IO3 | AF_11 |
GPIO_G | 10 | QSPI_BK2_IO2 | AF_10 |
GPIO_H | 3 | QSPI_BK2_IO1 | AF_10 |
GPIO_H | 2 | QSPI_BK2_IO0 | AF_10 |
WARNING: The QSPI programming in this device is done through AP[2] - Cortex-M4. In order to allow J-Link to communicate with the Cortex-M4 AP the STM32MP1xx needs to be set in "Engineering Boot Mode".
NOTE: If you wish to use a QSPI GPIO configuration different than the default provided one, please get in contact withSEGGER Support.