Mindmotion BIRD-F3F5 MM32F5287
This article describes specifics for the MindMotion BIRD-F3/F5 MM32F5287L8PV evaluation board.
Minimum requirements
- J-Link software V7.86i or later
Preparing for J-Link
- Connect the J-Link to the SWD header (J1)
- Power the board via USB-C (J5)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the MindMotion BIRD-F3/F5 MM32F5287.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86i
- Embedded Studio: V6.34
- Hardware: MindMotion BIRD-F3/F5 MM32F5287
- Link: File:MM PLUS5270 MM32F5270 TestProject ES V634.zip