e-peas EDMS105N EVK
This article describes specifics for the e-peas EDMS105N_EVK evaluation board.
[PICTURE OF BOARD]
450px
Preparing for J-Link
- Connect the J-Link to the following Pins:
- GND: CN4.1
- VTref: CN5.1
- SWDIO: JP7.3
- SWCLK_ JP7.1
- RESET: JP7.5
- Power the board via S1.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the e-peas EDMS105N_EVK.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.88k
- Embedded Studio: V6.34
- Hardware: e-peas EDMS105N_EVK
- Link: File:Epeas EDMS105N TestProject ES V634.zip