Difference between revisions of "ArteryTek AT-START-F402"
Line 1: | Line 1: | ||
__TOC__ |
__TOC__ |
||
− | This article describes specifics for the |
+ | This article describes specifics for the ArteryTek AT-START-F402 evaluation board.<br> |
[[File:Artery_AT-START-F402_AT32F402RCT7-7_board.jpg|450px]] |
[[File:Artery_AT-START-F402_AT32F402RCT7-7_board.jpg|450px]] |
||
Line 27: | Line 27: | ||
[[File:Artery_AT-START-F401_AT32F401RCT7-7_connect.png|400px]] |
[[File:Artery_AT-START-F401_AT32F401RCT7-7_connect.png|400px]] |
||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ArteryTek AT-START-F402.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
Revision as of 16:32, 8 February 2024
This article describes specifics for the ArteryTek AT-START-F402 evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | J1 | 32 | VDD |
GND | J1 | 31 | GND |
TDI | J1 | 18 | PA15 |
TMS/SWDIO | J1 | 14 | PA13/SWDIO |
TCK/SWCLK | J1 | 17 | PA14/SWCLK |
TDO/SWO | J1 | 23 | PB3 |
RESET | J2 | 9 | NRST |
- Power the board via USB CN3.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ArteryTek AT-START-F402.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94h
- Embedded Studio: V7.20
- Hardware: Artery AT-START-F402
- Link: File:Artery AT-START-F402 AT32F402RCT7-7 TestProject ES 7V20.zip