Difference between revisions of "ArteryTek AT-START-F413"

From SEGGER Wiki
Jump to: navigation, search
(→‎Preparing for J-Link)
(→‎Preparing for J-Link)
Line 24: Line 24:
 
| RESET || J1 || 25 || NRST
  
| RESET || J1 || 25 || NRST
 
|}
  
|}
−
*Power the board via USB (CN2 or CN3).
 +
*Power the board via CN4.
 
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
  
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
 
[[File:Artery_AT-START-F413_AT32F413RCT7_connect.png|400px]]
  
[[File:Artery_AT-START-F413_AT32F413RCT7_connect.png|400px]]

Revision as of 14:29, 26 January 2024

This article describes specifics for the Artery AT-START-F413 evaluation board.
Artery AT-START-F413 AT32F413RCT7 board.jpg

Preparing for J-Link

  • Connect the J-Link to this pins:
J-Link Pin Connector Pin Name
VTref J1 72 VDD
GND J1 71 GND
TDI J1 71 GND
TMS/SWDIO J1 33 PA13/SWDIO
TCK/SWCLK J1 37 PA14/SWCLK
TDO/SWO J1 61 PB3
RESET J1 25 NRST
  • Power the board via CN4.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Artery AT-START-F413 AT32F413RCT7 connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Artery AT-START-F413.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=ArteryTek_AT-START-F413&oldid=17571"