Difference between revisions of "ArteryTek AT-START-F435"
(Created page with "__TOC__ This article describes specifics for the Artery AT-START-F437 evaluation board.<br> 450px == Preparing for J-Lin...") |
|||
Line 1: | Line 1: | ||
__TOC__ |
__TOC__ |
||
− | This article describes specifics for the Artery AT-START- |
+ | This article describes specifics for the Artery AT-START-F435 evaluation board.<br> |
− | [[File:Artery_AT-START- |
+ | [[File:Artery_AT-START-F435_AT32F435ZMT7_board.jpg|450px]] |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
Line 27: | Line 27: | ||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Artery AT-START- |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Artery AT-START-F435.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
*J-Link software: V7.94g |
*J-Link software: V7.94g |
||
*Embedded Studio: V7.20 |
*Embedded Studio: V7.20 |
||
− | *Hardware: Artery AT-START- |
+ | *Hardware: Artery AT-START-F435 |
− | *Link: [[File:Artery_AT-START- |
+ | *Link: [[File:Artery_AT-START-F435_AT32F435ZMT7_TestProject_ES_7V20.zip]] |
Revision as of 13:02, 18 January 2024
This article describes specifics for the Artery AT-START-F435 evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | J1 | 72 | VDD |
GND | J1 | 71 | GND |
TMS/SWDIO | J1 | 33 | PA13/SWDIO |
TCK/SWCLK | J1 | 37 | PA14/SWCLK |
TDO/SWO | J1 | 61 | PB3 |
RESET | J1 | 25 | NRST |
- Power the board via USB (CN2 or CN3).
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Artery AT-START-F435.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94g
- Embedded Studio: V7.20
- Hardware: Artery AT-START-F435
- Link: File:Artery AT-START-F435 AT32F435ZMT7 TestProject ES 7V20.zip