Difference between revisions of "ArteryTek AT-START-F437"
(→Preparing for J-Link) |
|||
Line 24: | Line 24: | ||
*Power the board via USB (CN2 or CN3). |
*Power the board via USB (CN2 or CN3). |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
+ | [[File:Artery_AT-START-F437_AT32F437ZMT7_connect.png|400px]] |
||
− | '''[PICTURE OF CONNECT]''' |
||
− | [[File:VENDOR_DEVICE_CONNECT.PNG|400px]] |
||
== Example Project== |
== Example Project== |
Revision as of 12:37, 18 January 2024
This article describes specifics for the Artery AT-START-F437 evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | J1 | 72 | VDD |
GND | J1 | 71 | GND |
TMS/SWDIO | J1 | 33 | PA13/SWDIO |
TCK/SWCLK | J1 | 37 | PA14/SWCLK |
TDO/SWO | J1 | 61 | PB3 |
RESET | J1 | 25 | NRST |
- Power the board via USB (CN2 or CN3).
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Artery AT-START-F437.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94g
- Embedded Studio: V7.20
- Hardware: Artery AT-START-F437
- Link: File:VENDOR DEVICENAME TestProject ES V452b.zip