Difference between revisions of "ArteryTek AT-START-WB415"

From SEGGER Wiki
Jump to: navigation, search
(→‎Example Project)
(→‎Preparing for J-Link)
Line 9: Line 9:
 
! J-Link Pin || Connector !! Pin || Name
  
! J-Link Pin || Connector !! Pin || Name
 
|-
  
|-
−
| VTref || J1 || 32|| VDD
 +
| VTref || J1 || 22 || VDD
 
|-
  
|-
−
| GND || J1 || 31 || GND
 +
| GND || J1 || 24 || GND
 
|-
  
|-
−
| TDI || J1 || 18|| PA15
 +
| TMS/SWDIO || J2 || 10 || PA13/SWDIO
 
|-
  
|-
−
| TMS/SWDIO || J1 || 14 || PA13
 +
| TCK/SWCLK || J2 || 11 || PA14/SWCLK
 
|-
  
|-
−
| TCK/SWCLK || J1 || 17 || PA14
 +
| RESET || J2 || 24 || MCU_NRST
−
|-
  
−
| TDO/SWO || J1 || 23 || PB3
  
−
|-
  
−
| RESET || J2 || 7 || NRST
  
 
|}
  
|}
 
*Power the board via USB CN6.
  
*Power the board via USB CN6.

Revision as of 10:22, 2 February 2024

This article describes specifics for the Artery AT-START-WB413 evaluation board.
450px

Preparing for J-Link

  • Connect the J-Link to this pins:
J-Link Pin Connector Pin Name
VTref J1 22 VDD
GND J1 24 GND
TMS/SWDIO J2 10 PA13/SWDIO
TCK/SWCLK J2 11 PA14/SWCLK
RESET J2 24 MCU_NRST
  • Power the board via USB CN6.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

400px

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Artery AT-START-WB413.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=ArteryTek_AT-START-WB415&oldid=17604"