Difference between revisions of "ArteryTek AT-START-WB415"
(→Preparing for J-Link) |
m (Torben.scharping moved page Artery AT-START-WB413 to Artery AT-START-WB415) |
(No difference)
| |
Revision as of 10:50, 2 February 2024
This article describes specifics for the Artery AT-START-WB413 evaluation board.
450px
Preparing for J-Link
- Connect the J-Link to this pins:
| J-Link Pin | Connector | Pin | Name |
|---|---|---|---|
| VTref | J1 | 22 | VDD |
| GND | J1 | 24 | GND |
| TMS/SWDIO | J2 | 10 | PA13/SWDIO |
| TCK/SWCLK | J2 | 11 | PA14/SWCLK |
| RESET | J2 | 24 | MCU_NRST |
- Power the board via USB CN6.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Artery AT-START-WB413.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94i
- Embedded Studio: V7.20
- Hardware: Artery AT-START-F415
- Link: File:Artery AT-START-WB413 AT32WB413CCU7-7 TestProject ES 7V20.zip
