Difference between revisions of "ArteryTek AT-START-WB415"
m (Torben.scharping moved page Artery AT-START-WB415 to ArteryTek AT-START-WB415) |
|||
(One intermediate revision by the same user not shown) | |||
Line 1: | Line 1: | ||
__TOC__ |
__TOC__ |
||
− | This article describes specifics for the |
+ | This article describes specifics for the ArteryTek AT-START-WB415 evaluation board.<br> |
[[File:Artery_AT-START-WB415_AT32WB415CCU7-7_board.jpg|450px]] |
[[File:Artery_AT-START-WB415_AT32WB415CCU7-7_board.jpg|450px]] |
||
Line 24: | Line 24: | ||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ArteryTek AT-START-WB415.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
*J-Link software: V7.94i |
*J-Link software: V7.94i |
||
*Embedded Studio: V7.20 |
*Embedded Studio: V7.20 |
||
− | *Hardware: |
+ | *Hardware: ArteryTek AT-START-WB415 |
*Link: [[File:Artery_AT-START-WB415_AT32WB415CCU7-7_TestProject_ES_7V20.zip]] |
*Link: [[File:Artery_AT-START-WB415_AT32WB415CCU7-7_TestProject_ES_7V20.zip]] |
Latest revision as of 16:44, 8 February 2024
This article describes specifics for the ArteryTek AT-START-WB415 evaluation board.
450px
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | J1 | 22 | VDD |
GND | J1 | 24 | GND |
TMS/SWDIO | J2 | 10 | PA13/SWDIO |
TCK/SWCLK | J2 | 11 | PA14/SWCLK |
RESET | J2 | 24 | MCU_NRST |
- Power the board via USB CN6.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ArteryTek AT-START-WB415.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94i
- Embedded Studio: V7.20
- Hardware: ArteryTek AT-START-WB415
- Link: File:Artery AT-START-WB415 AT32WB415CCU7-7 TestProject ES 7V20.zip