Difference between revisions of "CMSemicon BAT32G133-EVB"
Thomas.haase (talk | contribs) (→Preparing for J-Link) |
Thomas.haase (talk | contribs) (→Preparing for J-Link) |
||
| Line 41: | Line 41: | ||
The output should look as follows:<br> |
The output should look as follows:<br> |
||
| − | [[File:BAT32G157GK_connect.png]] |
+ | [[File:BAT32G157GK_connect.png|400px]] |
== Example Project== |
== Example Project== |
||
Revision as of 11:18, 14 November 2022
Contents
This article describes specifics for the CMSemicon BAT32G1xxGx evaluation boards.
BAT32G133-EVB
PICTURE will follow
BAT32G157-EVB
PICTURE will follow
Minimum requirements
- J-Link software V7.__b or later
Preparing for J-Link
- Solder Header to the board (row on the side of the Chip)
| Device Side | J-Link Signal | Pin |
|---|---|---|
| CLK | SWCLK | 9 |
| DAT | SWDIO | 7 |
| RST | RESET | 15 |
| GND | GND | 4 |
| VDD | VTRef | 1 |
- Power the board via USB
- Verify the Connection with e.g. J-Link Commander.
You can use the following command line:
./JLink.exe -Device BAT32G157GK -If SWD -Speed 4000 -autoconnect 1
In case of BAT32G157GK - for other devices adopt the -device setting.
The output should look as follows:
400px
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the .
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82b
- Embedded Studio: V6.34
- Hardware:
- Link:
