Difference between revisions of "Flasher Hub-12"
(→Getting started) |
(Redirected page to UM08043 Flasher Hub-12) (Tag: New redirect) |
||
(5 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
+ | #REDIRECT [[UM08043_Flasher_Hub-12]] |
||
− | [[File: FlasherHub12.svg | thumb | SEGGER Flasher Hub-12]] |
||
− | |||
− | This is the user documentation for owners of a SEGGER Flasher Hub-12. |
||
− | |||
− | '''This article is work in progress.''' |
||
− | |||
− | |||
− | __TOC__ |
||
− | |||
− | = How Flasher Hub-12 works = |
||
− | |||
− | Flasher Hub-12 makes ultra-fast high speed parallel programming ("gang programming") with up to 12 channels possible. |
||
− | Flasher Hub-12 is connected to one or more modules (Flasher Compact). Each module is connected to a target chip. |
||
− | Using one of the Flasher Hub-12's host interfaces, flash programming operations can be triggered and responses from the Flasher Hub-12 can be read and evaluated. |
||
− | This makes the Flasher Hub-12 a perfect fit for small-scale as well as large-scale production environments. |
||
− | |||
− | = Getting started = |
||
− | |||
− | [[File: FlasherConfigFH12.png | thumb | Flasher Hub-12 listed in Flasher Configurator]] |
||
− | [[File: FlasherConfigFH12FWUpdate.png | thumb | Flasher Hub-12 firmware update via Flasher Configurator]] |
||
− | |||
− | Before putting the Flasher Hub-12 into operation, make sure to have the following devices at hand: |
||
− | |||
− | * Power supply (see below for more information) |
||
− | * One or more Flasher Compacts |
||
− | * Ethernet cable (not mandatory) |
||
− | * PC (Windows/ Linux/ macOS) |
||
− | * The Flasher Hub-12 is set up and good-to-go in less than 10 minutes |
||
− | |||
− | After making sure that the devices mentioned above are all available, the Flasher Hub-12 can be setup: |
||
− | |||
− | # Connect Flasher Hub-12 to power supply via the ''POWER'' connector |
||
− | # Connect Flasher Hub-12 to LAN via the ''LAN'' connector |
||
− | # Connect Flasher Compact(s) to Flasher Hub-12 via USB C |
||
− | # Download and install the most recent version of the Flasher software package |
||
− | #* https://www.segger.com/downloads/flasher/ |
||
− | # Start Flasher Configurator (''FlasherConfig.exe'') |
||
− | # Right-click on the Flasher Hub-12 |
||
− | # Click "''Update firmware''" |
||
− | # Open Flasher Hub-12's web interface by visiting http://flasherhub-<SerialNo>/ (Make sure to replace <SerialNo> with the serial number of your Flasher Hub-12) |
||
− | # Flasher Hub-12 is now up and running |
Latest revision as of 10:02, 26 October 2023
Redirect to: