Difference between revisions of "GigaDevice GD32103E-EVAL"
| (5 intermediate revisions by the same user not shown) | |||
| Line 2: | Line 2: | ||
This article describes specifics for the GigaDevice GD32103E-EVAL evaluation board.<br> |
This article describes specifics for the GigaDevice GD32103E-EVAL evaluation board.<br> |
||
| − | [[File:GigaDevice_GD32103E-EVAL_GD32F103ZE_picture.jpg| |
+ | [[File:GigaDevice_GD32103E-EVAL_GD32F103ZE_picture.jpg|680px]] |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
| Line 15: | Line 15: | ||
*Embedded Studio: V8.10b |
*Embedded Studio: V8.10b |
||
*Hardware: GigaDevice GD32103E-EVAL |
*Hardware: GigaDevice GD32103E-EVAL |
||
| − | *Link: [[File: |
+ | *Link: [[File:GigaDevice_GD32F103ZE_TestProject_ES_V810b.zip]] |
Latest revision as of 14:32, 5 April 2024
This article describes specifics for the GigaDevice GD32103E-EVAL evaluation board.
Preparing for J-Link
- Connect the J-Link to the JTAG header (JP1)
- Power the board via CN2.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32103E-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V8.10b
- Hardware: GigaDevice GD32103E-EVAL
- Link: File:GigaDevice GD32F103ZE TestProject ES V810b.zip
