GigaDevice GD32303E-EVAL

This article describes specifics for the GigaDevice GD32303E-EVAL evaluation board.

Preparing for J-Link

• Connect the J-Link to the JTAG header (JP1)
• Power the board via CN2.
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32303E-EVAL.
It is a simple Hello World sample linked into the internal flash.

SETUP

• Embedded Studio: V8.10b
• Hardware: GigaDevice GD32303E-EVAL
• Link: File:GigaDevice GD32F303ZE TestProject ES V810b.zip