Difference between revisions of "GigaDevice GD32330C-START"
(→Example Project) |
(→SETUP) |
||
Line 25: | Line 25: | ||
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32330C-START.<br>It is a simple Hello World sample linked into the internal flash.<br> |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32330C-START.<br>It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *Embedded Studio: V7. |
+ | *Embedded Studio: V7.12a |
*Hardware: GigaDevice GD32F303B-START |
*Hardware: GigaDevice GD32F303B-START |
||
*Link: [[File:GigaDevice_GD32330CB_TestProject_ES_V712a.zip]] |
*Link: [[File:GigaDevice_GD32330CB_TestProject_ES_V712a.zip]] |
Latest revision as of 16:52, 27 February 2024
This article describes specifics for the GigaDevice GD32330C-START evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | JP2 | 19 | +3V3 |
GND | JP2 | 20 | GND |
TMS/SWDIO | JP2 | 4 | PA13 |
TCK/SWCLK | JP3 | 7 | PA14 |
- Power the board via CN100.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32330C-START.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V7.12a
- Hardware: GigaDevice GD32F303B-START
- Link: File:GigaDevice GD32330CB TestProject ES V712a.zip