Difference between revisions of "GigaDevice GD32E230C-EVAL"
(Created page with "__TOC__ This article describes specifics for the GigaDevice GD32E230C-EVAL evaluation board. 450px == Minimum requirements == * J-Link sof...") |
(→Example Project) |
||
Line 35: | Line 35: | ||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32E230C-EVAL. It is a simple blinky application which toggles |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32E230C-EVAL. It is a simple blinky application which toggles LED1. The application is linked into the internal flash.<br> |
'''SETUP''' |
'''SETUP''' |
||
*J-Link software: V6.87b |
*J-Link software: V6.87b |
Latest revision as of 13:26, 9 October 2020
This article describes specifics for the GigaDevice GD32E230C-EVAL evaluation board.
Minimum requirements
- J-Link software V6.87b or later
Preparing for J-Link
The GD32E230C-EVAL does not come with a standard debug connector. Therefore, these signals have to be wired manually to connect the J-Link to the evaluation board. The following guide will describe how the GD32E230C-EVAL evaluation board can be connected to your J-Link.
- Populate the the pin header JP6
- Connect the board with jumping wires to your J-Link (see table below)
For information about the J-Link pinout please refer to the following page: J-Link SWD pinout.
J-Link 20 pin debug interface | Pin on evaluation board |
---|---|
Pin 1 (VTref) | +3V3 |
Pin 4 (GND) | GND |
Pin 7 (SWDIO) | PA13 |
Pin 9 (SWCLK) | PA14 |
The result should be looking like this:
- Power the board via the USB port (CN100).
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32E230C-EVAL. It is a simple blinky application which toggles LED1. The application is linked into the internal flash.
SETUP
- J-Link software: V6.87b
- Embedded Studio: V4.52b (or later)
- Hardware: GigaDevice GD32E230C-EVAL
- Link: File:GigaDevice GD32E230C TestProject ES V452b.zip