Difference between revisions of "GigaDevice GD32F303B-START"
(→Preparing for J-Link) |
|||
| Line 23: | Line 23: | ||
== Example Project== |
== Example Project== |
||
| − | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32F303B-START.<br>It is a simple Hello World sample linked into the internal flash.<br> |
====SETUP==== |
====SETUP==== |
||
| − | *J-Link software: V7. |
+ | *J-Link software: V7.94k |
*Embedded Studio: V7.20 |
*Embedded Studio: V7.20 |
||
| − | *Hardware: |
+ | *Hardware: GigaDevice GD32F303B-START |
*Link: [[File:VENDOR_DEVICENAME_TestProject_ES_V452b.zip]] |
*Link: [[File:VENDOR_DEVICENAME_TestProject_ES_V452b.zip]] |
||
Revision as of 14:53, 27 February 2024
This article describes specifics for the GigaDevice GD32F303B-START evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
| J-Link Pin | Connector | Pin | Name |
|---|---|---|---|
| VTref | JP3 | 1 | +V |
| GND | JP3 | 4 | G |
| TMS/SWDIO | JP3 | 2 | IO |
| TCK/SWCLK | JP3 | 3 | CK |
- Power the board via CN100.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32F303B-START.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94k
- Embedded Studio: V7.20
- Hardware: GigaDevice GD32F303B-START
- Link: File:VENDOR DEVICENAME TestProject ES V452b.zip
