Difference between revisions of "GigaDevice GD32F303B-START"
(→SETUP) |
(→SETUP) |
||
Line 25: | Line 25: | ||
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32F303B-START.<br>It is a simple Hello World sample linked into the internal flash.<br> |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32F303B-START.<br>It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: V7.94k |
||
*Embedded Studio: V7.20 |
*Embedded Studio: V7.20 |
||
*Hardware: GigaDevice GD32F303B-START |
*Hardware: GigaDevice GD32F303B-START |
Revision as of 15:13, 2 April 2024
This article describes specifics for the GigaDevice GD32F303B-START evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | JP3 | 1 | +V |
GND | JP3 | 4 | G |
TMS/SWDIO | JP3 | 2 | IO |
TCK/SWCLK | JP3 | 3 | CK |
- Power the board via CN100.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32F303B-START.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V7.20
- Hardware: GigaDevice GD32F303B-START
- Link: File:GigaDevice GD32F303B-START GD32F303CB TestProject ES 7V20.zip