Difference between revisions of "GigaDevice GD32F303B-START"
Line 2: | Line 2: | ||
This article describes specifics for the GigaDevice GD32F303B-START evaluation board.<br> |
This article describes specifics for the GigaDevice GD32F303B-START evaluation board.<br> |
||
+ | [[File:GigaDevice_GD23F303B-START_GD32F303CB_board.jpg|450px]] |
||
− | '''[PICTURE OF BOARD]''' |
||
− | [[File:VENDOR_BOARDNAME.jpg|450px]] |
||
== Preparing for J-Link == |
== Preparing for J-Link == |
Revision as of 14:37, 27 February 2024
This article describes specifics for the GigaDevice GD32F303B-START evaluation board.
Preparing for J-Link
- Connect the J-Link to ......
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | |||
GND | |||
nTRST | |||
TDI | |||
TMS/SWDIO | |||
TCK/SWCLK | |||
RTCK | |||
TDO/SWO | |||
RESET | |||
DBGRQ | |||
5V-Supply |
- Power the board via........
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.xx
- Embedded Studio: V7.20
- Hardware: [SiliconVendor] [EvalBoardName]
- Link: File:VENDOR DEVICENAME TestProject ES V452b.zip