GigaDevice GD32F303B-START
Revision as of 14:46, 27 February 2024 by Torben.scharping (talk | contribs) (→Preparing for J-Link)
This article describes specifics for the GigaDevice GD32F303B-START evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | JP3 | 1 | +V |
GND | JP3 | 4 | G |
TMS/SWDIO | JP3 | 2 | IO |
TCK/SWCLK | JP3 | 3 | CK |
- Power the board via CN100.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.xx
- Embedded Studio: V7.20
- Hardware: [SiliconVendor] [EvalBoardName]
- Link: File:VENDOR DEVICENAME TestProject ES V452b.zip